Causes Of A Flooded Motorcycle Engine

How to Fix a Flooded Motorcycle Engine

Causes of a Flooded Motorcycle Engine

A flooded motorcycle engine can occur for several reasons, including:

• Over-choking the engine
• Leaving the fuel petcock on while the motorcycle is not running
• A faulty carburetor or fuel injector
• A dirty air filter

Signs of a Flooded Motorcycle Engine

Some common signs that your motorcycle engine may be flooded include:

• Difficulty starting the engine
• Black smoke coming from the exhaust
• Engine running rough or stalling
• Fuel smell coming from the engine

How to Fix a Flooded Motorcycle Engine

If you believe your motorcycle engine is flooded, here are some steps you can take to fix it:

1. Stop Attempting to Start the Engine

If you've found yourself with a flooded motorcycle engine, the first thing you should do is stop attempting to start it. Continued attempts to start a flooded engine can worsen the problem and make it more difficult to fix.

2. Allow Your Engine to Idle for a Short Time

If you start your bike just to move it out of the garage to the drive, then allow your engine to idle for a short time to help evaporate any excess fuel. This can sometimes clear the flooding and allow you to start your bike normally.

3. Drain the Air Compressor Tank

If you have an air compressor, you can use it to help drain the excess fuel from your motorcycle's engine. Simply connect the air hose to your engine's spark plug hole and turn on the compressor. This will force air into the engine and help push out any excess fuel.

4. Remove the Water from the Exhaust

If your motorcycle has been submerged in water, it's important to remove any water that may have gotten into the exhaust system. To do this, tip your bike backward as if you were doing a wheelie to allow the water to drain out.

5. Check the Spark Plugs

Once you've removed the excess fuel and water from your motorcycle's engine, check the spark plugs. If the spark plugs are wet with fuel, they may need to be replaced. Dry the spark plugs with a clean cloth and reinstall them.

6. Start Your Motorcycle

Once you've completed the above steps, try starting your motorcycle. If the engine starts, but runs rough, you may need to adjust the carburetor or fuel injector. If the engine doesn't start, you may need to take it to a mechanic for further diagnosis.